The SMPS PS-10 charger delivers a 12V voltage and a 5A intensity. SMPS means 'switched-mode power supply', therefore the SMPS PS-10 charger regulates the voltage while minimizing energy loss.
It allows to recharge the LB-012 batteries through the LBC-010 charger, and to power the CM-5, CM-510 and CM-530, CM-700, OpenCR boards and the OpenCM-485 expansion board.
The SMPS PS-10 charger is also compatible with the SMPS2Dynamixel and U2D2 power board to power your Dynamixel servomotors if you use them without a controller (with a UBS2Dynamixel, USB2AX or U2D2 module).
Since it has a standard 5.5x2.5 mm jack connector, it is also compatible with many other products.
Power Supply and Recharging Device, supplies power for the LIPO Battery Charger LBC-10 for charging
Specifications:
- 12V 5A SMPS
- 50~60Hz
- Input : 100~260V AC (Free Volt)
Compatible Products :
Controller : CM-5, CM-510, CM-530, CM-2+, CM-700, OpenCM 485 Expansion Board, OpenCR
Platform : PREMIUM, GP, DARwIn-OP, ROBOTIS OP2, ROBOTIS OP3, 3 Finger Hand
Etc.: SMPS2Dynamixel, LIPO Battery Charger LBC-010
How to Use
SMPS -> Controller -> DYNAMIXEL
SMPS -> OpenCM 485 Expansion Board -> DYNAMIXEL
SMPS -> DARwIn-OP or ROBOTIS OP Power Board
SMPS -> SMPS2Dynamixel -> DYNAMIXEL
SMPS -> Battery Charger -> Battery (charge)
How to Use
SMPS -> Controller -> DYNAMIXEL
SMPS -> OpenCM 485 Expansion Board -> DYNAMIXEL
SMPS -> DARwIn-OP or ROBOTIS OP Power Board
SMPS -> SMPS2Dynamixel -> DYNAMIXEL
SMPS -> Battery Charger -> Battery (charge)
