Characteristics
- Lithium Polymer rechargeable battery for DARwIn-OP only.
- PCM is embedded to protect from overcharging, discharge, and excess current.
- Can not be used with the BIOLOID due to connector difference.
- Battery case/cover and extension cable not included.
What's included
- 1 x LIPO Battery 11.1V 1800mAh LB-012
**Charger sold separately.
Specifications
Weight | 106g |
Dimension | 88 x 35 x 26mm |
Voltage | 11.1V |
Capacity | 1800mAh |
Etc. | PCM Embedded (Protection from overcharging, discharge, and excess current) |
Precautions
- Do not drop or fold any part of the battery or cables.
- Do not fold the end of the sutured portion.
- Do not apply heat, water, or any other liquid on the battery.
- Do not place it in the microwave, washing machine, or dryer.
- Do not use damaged batteries. (inflated, deformed, damaged, etc)
- Do not short circuit the polarity.
- Do not take the battery apart.
- When charging, make sure the battery is connected into the correct polarity.
- Do not charge when the battery is hot. Please charge after it has cooled off.
- Battery will not charge when connected to the robot.
* When the battery is not being used or fully charged, please do not have it connected to a device.
STORAGE PRECAUTIONS:
- Detach the battery from the robot or controller when storing away.
- When storing away the battery for a long time, make sure the battery life is somewhere around 50%.
- Do not store it in wet or hot places.
- Please check your batery state every 4 months. Due to the internal circuit of the battery it will drain some watts over time so if you leave it stored for long periods it may discharge to a point where it cannot be charged again
Compatible products
- Robot : Robotis OP2, TurtleBot
- Charger : LIPO Battery Charger LBC-10
** NOT compatible with CM-series controllers.